Specifications

Diamond-MM-32
10-11
The following table is a list of the ranges for this driver and the corresponding
range codes. The D/A specific jumpers on the board have to be in the correct
positions for the ranges entered.
For example, if the first channel is 0 to + 10 volts and the second channel is 0
to +5 volts, enter
[10,5]
Sample Time - Enter the base sample time or a multiple of the base sample
time.
BaseAddress - Enter the base address of the board. This entry must
correspond to the DIP-switch settings on the board. For example, if the base
address is 300 (hexadecimal), enter
0x300
Diamond-MM-32 Digital Input
The Diamond-MM-32 has one 8255 chip with 3 ports (A,B,C). Each port has a
maximum of 8 digital I/O lines that can be configured as inputs or outputs.
Use a separate diver block for each port. By selecting the digital input driver
block, the port is configured as input.
Scaling Input to Output
Input range (V) Range code Input range (V) Range code
-10 to +10 -10 0 to +10 10
-5 to +5 -5 0 to +5 5
Hardware Input Block Output Data Type Scaling
TTL double TTL low = 0.0
TTL high = 1.0