Specifications

Diamond-MM
10-5
Sample Time - Enter the base sample time or a multiple of the base sample
time.
BaseAddress - Enter the base address of the board. This entry must
correspond to the DIP-switch settings on the board. For example, if the base
address is 300 (hexadecimal), enter
0x300
Diamond-MM Analog Output (D/A)
Scaling Input to Output
Driver Block Parameters
Channel Vector - This parameter is a combined Channel Vector and Range
Vector. The number of elements defines the number of D/A channels used.
Enter a range code for each of the D/A channels used. This driver allows a
different range for each channel with a maximum of 2 channels.
The following table is a list of the ranges for this driver and the corresponding
range codes. The D/A specific jumpers on the board have to be in the correct
positions for the ranges entered.
For example, if the first channel is 0 to + 10 volts and the second channel is 0
to +5 volts, enter
[10,5]
Hardware Output Block Input Data Type Scaling
volts double 1
Input range (V) Range code Input range (V) Range code
0 to +10 10
0 to +5 5