Specifications

10 Diamond
10-4
Diamond-MM Analog Input (A/D)
Scaling Input to Output
Driver Block Parameters
Number of Channels - If you entered 16 in the MUX box, then enter a
number between 1 and 16 to select the number of single A/D channels used. If
you entered 8 in the MUX box, then enter a number between 1 and 8 to select
the number of differential A/D channels used. This driver does not allow the
selection of individual channels or a different MUX setting for each channel.
Input Range - Enter an input range code for all A/D channels. This driver does
not allow the selection of a different range for each channel. The input range is
the same for all A/D channels.
The following table is a list of the ranges for this driver and the corresponding
range codes.
The gain jumpers on the board have to be in the correct positions for the chosen
range.The bipolar jumper on the board has to be in the bipolar position, if a
bipolar range is used or in the unipolar position, when a unipolar range is used.
MUX (16/8) - Enter
16 for single-ended or 8 for differential A/D channels. This
entry must correspond to the MUX-switch setting on the board.
Hardware Input Block Output Data Type Scaling
volts double 1
Input range (V) Range code Input range (V) Range code
-10 to +10 -10 0 to +10 10
-5 to +5 -5 0 to +5 5
-2.5 to + 2.5 -2.5 0 to +2 2
-1 to +1 -1 0 to +1 1
-0.5 to +0.5 -5