Specifications

9 ComputerBoards
9-118
Number the channels beginning with 1 even if the board manufacturer starts
numbering the channels with 0.
Range Vector - Enter a range code for each of the channels in the channel
vector. The range vector must be the same length as the channel vector. This
board allows the range of each channel to be different.
The following table is a list of the ranges for this driver and the corresponding
range codes.
For example, if the first channel is -10 to +10 volts, and the second channel is
0 to 5 volts, enter
[-10,5]
The range settings have to correspond to the DIP-switch settings on the board.
Also the Bipolar/ Unipolar jumpers have to be placed according to the ranges
used.
Sampletime - Base sample time of a multiple of the base sample time.
PCI Slot (-1:autosearch) - Enter a number between -1 and n.
If only one board of this type is physically present in the target PC, enter
-1
If two or more boards of this type are physically present in the target PC, enter
the PCI slot number of the board associated with this driver block.
PCI-DAS1200 Digital Input
The PCI-DAS1200 has one 8255 chip with 3 ports (A,B,C). Each port has a
maximum of 8 digital I/O lines that can be configured as inputs or outputs.
Use a separate diver block for each port. By selecting the digital input driver
block, the port is configured as input.
Input range (V) Range code Input range (V) Range code
-10 to +10 -10 0 - 10 10
-5 to +5 -5 0 - 5 5