Specifications

9 ComputerBoards
9-100
PC104-DAS16JR/12 Digital Output
Scaling Input to Output
Driver Block Parameters
Number of Channels - Enter a number between 1 and 4 to select the number
of digital output lines used. This driver does not allow the selection of
individual digital output lines.
Sampletime - Enter the base sample time or a multiple of the base sample
time.
BaseAddress - Enter the base address of the board. It is important that this
entry corresponds to the DIP-switch settings on the board. For example, if the
base address is 300 (hexadecimal), enter
0x300
The switch and jumper settings, that are not mentioned here, have no influence
on the running of xPC Target.
Hardware Output Block Input Data Type Scaling
TTL double < 0.5 = TTL low
>
0.5 = TTL high