Specifications

9 ComputerBoards
9-96
Number the channels beginning with 1 even if the board manufacturer starts
numbering the channels with 0.
Range Vector - Range code for each of the channels in the channel vector. The
range vector must be the same length as the channel vector. This board allows
the range of each channel to be different.
The following table is a list of the ranges for this driver and the corresponding
range codes.
For example, if the first channel is -10 to +10 volts, and the second channel is
0 to 5 volts, enter
[-10,5]
The range settings have to correspond to the jumper settings on the board.
Sampletime - Base sample time of a multiple of the base sample time.
BaseAddress - Enter the base address of the board. It is important that this
entry corresponds to the DIP-switch settings on the board. For example, if the
base address is 300 (hexadecimal), enter
0x300
The jumpers by the range DIP-switches on the board all have to be in the XFER
position. The Wait-State jumper has to be in the off position.
Input range (V) Range code Input range (V) Range code
-10 to +10 -10 0 - 10 10
-5 to +5 -5 0 - 5 5