Specifications

CIO-PDISO16
9-87
Scaling Input to Output
Driver Block Parameters
Number of Channels - Enter a number between 1 and 8 to select the number
of digital input lines used with this connector. This driver does not allow the
selection of individual digital input lines.
Section(Connector) - From the list, choose either 1 (nearest to backplate)
or 2 (farthest from backplate to select the connector used.
Sampletime. Enter the base sample time or a multiple of the base sample
time.
BaseAddress - Enter the base address of the board. It is important that this
entry corresponds to the DIP-switch settings on the board. For example, if the
base address is 300 (hexadecimal), enter
0x300
The Wait-State jumper has to be in the off position.
The switch and jumper settings, that are not mentioned here, have no influence
on the running of xPC Target.
Hardware Input Block Output Data Type Scaling
5 to 24 volts DC/AC double ~0 volts = 0.0
5 to 24 volts = 1.0