Specifications

CIO-DO24DD
9-85
output lines in any order. The number of elements defines the number of digital
lines used.
For example, to use all of the digital outputs for one port, enter
[1,2,3,4,5,6,7,8]
Number the lines beginning with 1 even if the board manufacture starts
numbering the lines with 0.
Port - From the list choose either A, B, or C. The I/O board has a 8255 chip
with 3 ports. The Port parameter defines which port of the 8255 chip is used
for this driver block. Each port has a maximum or 8 digital lines that can be
configured as inputs or outputs depending on which driver block is chosen. In
each case, one block is needed for each port.
Sampletime - Enter a base sample time or a multiple of the base sample time.
BaseAddress - Enter the base address of the board. This entry must
corresponds to the DIP-switch settings on the board. For example, if the base
address is 300 (hexadecimal), enter
0x300