Specifications

CIO-DAS1602/12
9-45
CIO-DAS1602/12 Analog Input (A/D)
Scaling Input to Output
Driver Block Parameters
Number of Channels - If single-ended is chosen from the MUX list, then
enter a number between 1 and 16 to select the number of A/D channels used. If
differential is chosen from the MUX list, then enter a number between 1 and 8
to select the number of A/D channels used. This driver does not allow the
selection of individual channels or to mix single-ended and differential inputs.
Range - From the list, choose either +-10V (-10 volts to +10 volts), +-5V,
+-2.5V, +-1.25V, +-0.625V, 0-10V, 0-5V, 0-2.5V, or 0-1.25V.This driver does
not allow the selection of a different range for each channel.
If a bipolar range is used, the bipolar switch on the board must be in the bipolar
position. if a unipolar range is used, the bipolar switch must be in the unipolar
position.
MUX - From the list, choose either single-ended(16 channels) or
differential (8 channels). This choice must correspond to the MUX-switch
setting on the board.
Sampletime - Enter the base sample time or a multiple of the base sample
time.
BaseAddress - Enter the base address of the board. It is important that this
entry corresponds to the DIP-switch settings on the board. For example, if the
base address is 300 (hexadecimal), enter
0x300
Hardware Input Block Output Data Type Scaling
volts double 1