Specifications

8 Burr-Brown
8-12
Port Number (0-3) - Enter a number from 1 to 3 to identify the port used with
this block of digital input lines.
Sample Time - Enter a base sample time or a multiple of the base sample
time.
Module Number (1-3) - Enter a number from 1 to 3 to identify the connector
on the carrier board where the I/O module is inserted. This driver verifies if the
module is placed on the specified module connector.
BaseAddress or Carrier Board (ie: 0xd000) - Enter the base address of the
board. This entry must correspond to the DIP-switch settings on the board. For
example, if the base address is 300 (hexadecimal), enter
0x300
PCI-20041C Digital Output
Use a separate diver block for each port. By selecting the digital output driver
block, the port is configured as output.
Scaling Input to Output
Driver Block Parameters
Number of Channels - Enter a number between 1 and 8 to select the number
of digital output lines used with this port.
Port Number (0-3) - Enter a number from 1 to 3 to identify the port used with
this block of digital output lines.
Sample Time. Enter a base sample time or a multiple of the base sample time.
Module Number (1-3) - Enter a number from 1 to 3 to identify the connector
on the carrier board where the I/O module is inserted. This driver verifies if the
module is placed on the specified module connector.
Hardware Output Block Input Data Type Scaling
TTL double < 0.5 = TTL low
>
0.5 = TTL high