Specifications

8 Burr-Brown
8-6
Input Range - Enter an input range code for all A/D channels. This driver does
not allow the selection of a different range for individual channel. The input
range is the same for all A/D channels
The following table is a list of the ranges for this driver and the corresponding
range codes.
The jumpers W1 to W5 on the module must correspond to this range setting.
Sample Time - Enter a base sample time or a multiple of the base sample
time.
Module Number (1-3) - Enter a number from 1 to 3 to identify the connector
on the carrier board where the I/O module is inserted. This driver verifies if the
module is placed on the specified module connector.
BaseAddress of Carrier Board (ie. 0xd000) - Enter the base address of the
board. This entry must correspond to the DIP-switch settings on the board. For
example, if the base address is 300 (hexadecimal), enter
0x300
Other jumper on this board.
The switch and jumper settings, that are not
mentioned here, have no influence on the running of xPC Target.
Input range (V) Range code Input range (V) Range code
-10 to +10 -10 0 - 10 10
-5 to +5 -5 0 - 5 5
-2.5 to +2.5 -2.5
Jumper
Number
Jumper Jumper
Number
Jumper
W6 out W22 out
W8 in W27 out
W10 out W30 -