Specifications

5 CAN I/O Support for FIFO
5-22
CAN FIFO Driver Blocks for the CAN-AC2-104 with Philips
SJA1000 CAN-Controller
The driver blocks described here support the CAN-AC2-104 (PC/104) using
FIFO mode. The Philips SJA1000 chip is used as the CAN controller in this
configuration and supports both Standard and Extended identifier ranges in
parallel. The driver block set for this board is found in the xPC Target I/O block
library in the group CAN/Softing.
The fourth block group highlighted above contains the FIFO Mode sub group.
The highlighted group then contains all driver blocks available for FIFO Mode
CAN.