Specifications

5 CAN I/O Support for FIFO
5-6
CAN FIFO driver blocks for the CAN-AC2-PCI with Philips
SJA1000 CAN-Controller
The driver blocks described here support the CAN-AC2-PCI using FIFO mode.
The Philips SJA1000 chip is used as the CAN controller in this configuration
and supports both Standard and Extended identifier ranges in parallel. The
driver block set for this board is found in the xPC Target I/O block library in
the group CAN/Softing.
The third block group highlighted above contains the FIFO mode sub group.
The highlighted group then contains all driver blocks available for FIFO Mode
CAN.