Specifications

CAN driver blocks for the CAN-AC2-104 (PC/104) with Philips SJA1000 CAN-Controller
4-31
CAN driver blocks for the CAN-AC2-104 (PC/104) with
Philips SJA1000 CAN-Controller
The driver blocks described here support the CAN-AC2-104 (PC/104). The
Philips SJA1000 chip is used as the CAN-controller in this configuration and
supports both Standard and Extended identifier ranges in parallel. The driver
block set for this board is found in the xPC Target I/O block library in the group
CAN/Softing.
The fourth block group highlighted above contains the three available CAN
blocks: Setup, Send, and Receive.