User`s guide

7 Analysis and Enhancement
The Bus Selector block still needs to be connected. You cannot configure
the parameters of this block until you connect an input signal to it.
14 Configur
e the Bus Selector block. Double-click the block. In the Signals
in the bus
pane, select
signal3.ClickSelect to move signal3 to the
Selecte
dsignalspane. Click OK.
The Bus Selector block now has three output ports.
15 Connect the Bus Selector block to the Reshape blocks.
16 Set the c
onfiguration parameters. Open t he Configuration dialog box by
selecti
ng Configuration Parameters from the Simulation menu. Set
the para
meters as follows:
• Solver p
ane, Stop time =
0
• Solver p
ane, Type =
Fixed-step
• Solver p
ane, Solver =
discrete (no continu ous states)
17 Run the model.
7-64