User`s guide

5 Geometri c Transformation
• Counter size = 16 bits
• Output = Count
• Clear the Reset input check box.
• Sample time =
1/30
The Counter block counts upward until it reaches the maximum value that
can be represented by 16 bits. Then, it starts again at zero. You can view its
output value on the Display block while the simulation is running. You are
using the Counter block from Signal Processing Blockset because its Count
data type parameter enables you to specify the data type of its output.
10 Use the Gain block to convert the output of the Counter block from degrees
to radians. Set the Gain parameter to
pi/180.
11 Connect the blocks as shown in the following figure.
5-10