User`s guide

2 Embedded Target for TI C6000 DSP 1.1 Release Notes
2-8
Upgrading from an Earlier Release
This section describes the upgrade issues involved in moving from the
Embedded Target for TI C6000 DSP Version 1.0 to Embedded Target for TI
C6000 DSP Version 1.1.
Version 1.1 requires the following MathWorks products:
• MATLAB 6.5.1
• Real-Time Workshop 5.1
• Signal Processing Toolbox 6.1
• Simulink 5.1
• MATLAB Link for Code Composer Studio
®
Development Tools 1.1
• DSP Blockset 5.1
• Fixed-Point Blockset 4.1 (recommended)
To upgrade your current Embedded Target for TI C6000 DSP Version 1.0 to
Version 1.1, you need to:
• Upgrade CCS to Version 2.12
• Install and upgrade the required MathWorks products
Upgrade CCS to Version 2.12
Note This procedure assumes that you already installed CCS 2.1 and added
the patch as required for Embedded Target for TI C6000 DSP 1.0. If not, refer
to “Installing Embedded Target for TI C6000 DSP” on page 2-6.
1 Install the appropriate version of Texas Instruments Code Composer
Studio 2.12. Note that the Embedded Target does not support targeting with
the C5000 DSP family.
- To target C6000 hardware, install the Code Composer Studio Version 2.12
for TMS320C6000.