User`s guide

2 Embedded Target for TI C6000 DSP 1.1 Release Notes
2-6
Installing Embedded Target for TI C6000 DSP
This section describes how to install Embedded Target for TI C6000 DSP 1.1
for the first time. If you already installed Version 1.0, refer to “Upgrading from
an Earlier Release” on page 2-8 for information about upgrading to this new
version.
Version 1.1 requires the following MathWorks products:
• MATLAB 6.5.1
• Real-Time Workshop 5.1
• Simulink 5.1
• Signal Processing Toolbox 6.1
• MATLAB Link for Code Composer Studio
®
Development Tools 1.1
• DSP Blockset 5.1
• Fixed-Point Blockset 4.1 (recommended)
You can install these products before or after you install CCS 2.12.
Install CCS 2.12
Perform the following steps to install CCS 2.12:
1 Install the appropriate version of Texas Instruments Code Composer
Studio 2.1. Note that the Embedded Target does not support targeting with
the C5000 DSP family.
- To target C6000 hardware, install the Code Composer Studio Version 2.1
for TMS320C6000.
2 Download and apply a patch for DSP/BIOS—“CCStudio v2.1 - Config Server
Registration Fix”—to Code Composer Studio 2.1. You can apply this patch
to CCS version 2.1 only. The patch is available only from the following URL:
<https://www-a.ti.com/downloads/sds_support/
ALL-2.00-SA-to-TI-BIOSRTA-REG01.htm>
3 Install the appropriate version of Texas Instruments Code Composer
Studio 2.12. Note that the Embedded Target does not support targeting with
the C5000 DSP family.