Installation guide

Creating Advanced Configurations
To set up this configuration, follow these instructions:
1 Perform a stand-alone installation of the products for which you have an
Individual license, if you have not already done so. Use the PLP for your
Individual license in this installation. See "Overview of Steps in Standard
Installation Procedure" on page 1-2 to leam how.
2 Move the License File (license. dat) processed by the installer during
this installation out ofthe matJaibroot\bin\win32 folder to any convenient
folder, such as the desktop.
3 Run the installer again, this time to install the toolboxes that have a
Concurrent license. Use the PLP for your concurrent license in this
installation. See "Overview of Steps in Network Installation Procedure"
on page 2-5 for more information.
4 Specify the location of the License File on your license server
(mat2abroot\flexlm\license.dat) when asked by the installer—see "Step
4: Specify Location of License File" on page 2-11.
5 Specify the same installation folder as your stand-alone installation and
select only the products you want to use that are not already part of your
Individual license installation—see "Step 7: Specify Installation Folder"
on page 2-15.
6 After the installation is finished, rename the License File that
was processed by the installer during this installation. Open the
matlabroot \ bin \ Win32 folder and change the name ofthe license.dat
file to license.lie.
7 Move the original License File, license. dat, that was created during the
standalone installation, back into the /natiabr'oot\bin \Win32 folder.
8 Start MATLAB. You can now run the toolboxes with a concurrent license
from your stand-alone installation.
3-23