Installation guide

Overview of Steps in Network Installation Procedure
Overviev^ of Steps in Network Installation Procedure
The following table summarizes the steps in the network installation
procedure. The sections that follow provide more detailed information about
each step. If you encounter any trouble during installation, see Chapter 4,
"Troubleshooting" for answers to some common installation problems.
You use this procedure for installations in both remote access and local access
configurations. For either configuration, you must first install the license
manager on your license server. During this installation, the MathWorks
Installer performs some necessary processing of your License File. You will
use this processed License File for all subsequent client installations. See
"Installing MATLAB on a Client System" on page 2-28 for more information.
For remote access configurations, you must also install MATLAB on your
license server. You can install MATLAB and the license manager at the same
time.
Instead of performing this procedure, and answering the questions posed by
each dialog box, you can run the installer noninteractively. In this mode, all
the information you would normally provide using the installer dialog boxes
you enter in an initialization file. For more information, see "Running the
Installer Noninteractively" on page 3-28.
: Network installatipn. Procedure; ^;. •;'...•:; ':'"\ '•.,/; •;••":"•• V :•'••• j|:
Step 1: Before you install
Step 2: Start the installer
Step 3: Enter identification and license information
Step 4: Specify location of License File
Step 5: Review the software licensing agreement
Step 6: Specify t3rpe of installation (must choose Custom)
Step 7: Specify installation folder
Step 8: Specify the products you want to install
Step 9: Configure the license manager as a service
Step 10: Specify installation options
2-5