Installation guide

Overview of Steps in Standard Installation Procedure
Step 10: Read Product Configuration Notes
Depending upon which products you install, the MathWorks Installer might
display a dialog box containing two types of information:
• Product conflguration infonnation — Certain products require
additional configuration. If you installed one of these products, the
installer lists the configuration commands in this dialog box. You can copy
this command to your system clipboard for use after the installation is
completed—see "Configuring Certain Products" on page 1-21.
• Available product updates — If your PLP identifies products that
are not on any of the CDs, and you are not currently connected to the
Internet or you chose not to download product updates, the installer lists
them in this dialog box. After installation is complete, you must go to the
MathWorks Web site to download these products.
Click Next to proceed with the installation.
-i Pruduct Contiguratinn Notes
5^^:
^jn}xl
,^1VMalli\M)rk.>:
Your InstaBation may require additional configuration steps. Ses the notes below for
instructions:
1. There are updated products available.
When you have finished installing, go to www.mathworks.com to get your updated
products. The folloviring products have newer versions available on the Web site:
Simulink®
2. There are new products available.
When you have finished installing, you can go to www.mathworks.com to dovmload
the following products:
Aerospace Blockset
Next > >|
d
Cjricel Help
Click Next
1-17