User`s guide

Using Ha mmerstein-Wiener Plots to Validate Models
Note The Hamm-Wiener check b ox is unavailable if you do not have a
Hammerstein-Wiener m odel in the Model Board.
To include or exclude a model on the plot, click the corresponding model icon
in the System Identification Tool G U I. Active models display a thick line
inside the model icon, as shown in the following figure.
Hide or show
the top pane.
Supported plots
for linear block
Selected block
is highlighted.
After y ou generate a plot, you can learn more about your model by:
• “Plotting Nonlinear Block Characteristics” on page 8-58
• “Plotting Linear Block Characteristics” on page 8 -59
8-57