User`s guide

26 Create Custom Configurations by Organizing Checks and Folders
26-18
Verify and Use Custom Configurations
In this section...
“Update the Environment to Include Your sl_customization File” on page 26-18
“Verify Custom Configurations” on page 26-18
Update the Environment to Include Your sl_customization File
When you start Simulink, it reads customization (sl_customization.m) files. If you
change the contents of your customization file, update your environment by performing
these tasks:
1
If you previously started the Model Advisor:
a
Close the model from which you started the Model Advisor
b
Clear the data associated with the previous Model Advisor session by removing
the slprj folder from your working folder.
2
At the MATLAB command line, enter:
sl_refresh_customizations
3
Open your model.
4
Start the Model Advisor.
Verify Custom Configurations
To verify a custom configuration:
1
If you created custom checks, or created the custom configuration using the
sl_customization method, update the Simulink environment. For more
information, see “Update the Environment to Include Your sl_customization File” on
page 26-18.
2
Open a model.
3
From the model window, start the Model Advisor.
4
Select Settings > Load Configuration. If you see a warning that the Model
Advisor report corresponds to a different configuration, click Load to continue.
5
In the Open dialog box, navigate to and select your custom configuration. For
example, if you created the custom configuration in “Organize Checks and