User`s guide

Organize Checks and Folders Using the Model Advisor Configuration Editor
26-9
To... Select...
Edit > Move down
The check or folder and drag and drop
Rename checks and folders
Note: MathWorks folder display names are
restricted. When you rename a folder, you
cannot use the restricted display names.
The check or folder and edit Display Name in
right pane.
Allow or gray out the check box control for
checks and folders
Tip This capability is equivalent to enabling
checks, described in “Display and Enable
Checks”.
Edit > Enable
Edit > Disable
Save the configuration as a MAT file for use and
distribution
File > Save
File > Save As
Set the configuration so it opens by default in
the Model Advisor
File > Set Current Configuration as Default
Restore the MathWorks default configuration File > Restore Default Configuration
Load and edit saved configurations File > Open
Start the Model Advisor Configuration Editor
Note:
• Before starting the Model Advisor Configuration Editor, verify that the current folder
is writable. If the folder is not writable, you see an error message when you start the
Model Advisor Configuration Editor.
• The Model Advisor Configuration Editor uses the Simulink project (slprj) folder (for
details about storing reports and other relevant information, see “Model Reference
Simulation Targets”) in the current folder. If this folder does not exist in the current
folder, the Model Advisor Configuration Editor creates it.