User`s guide

Link to Requirements in Microsoft Word Documents
2-29
• Enable Modify destination for bi-directional linking.
When you select this option, every time you create a selection-based link from
a model object to a requirement, the RMI inserts navigation objects at the
designated location.
For more information about the settings, see “Requirements Settings” on page 2-16.
6
Double-click the fuel rate controller subsystem to open it.
7
Open the Airflow calculation subsystem.
8
Right-click the Pumping Constant block and select Requirements Traceability >
Link to Selection in Word.
The RMI inserts a bookmark at that location in the requirements document and
assigns it a generic name, in this case, Simulink_requirement_item_7.
9
To verify that the link was created, select Analysis > Requirements Traceability
> Highlight Model.
The Pumping Constant block, and other blocks with requirements links, are
highlighted.
10
To navigate to the link, right-click the Pumping Constant block and select
Requirements Traceability > 1. “Determination of pumping efficiency”.
The section 2.2 Determination of pumping efficiency is displayed, selected in
the requirements document.
Keep the example model and the requirements document open.
View Link Details
To view the details of the link that you just created, right-click the Pumping Constant
block and select Requirements Traceability > Open Link Editor.
The Requirements Traceability Link Editor opens.