User`s guide

Limit Model Checks By Excluding Gain and Outport Blocks
22-11
Limit Model Checks By Excluding Gain and Outport Blocks
This example shows how to exclude a gain block and all outport blocks from a Model
Advisor check during a Model Advisor analysis. By excluding individual blocks
from checks, you limit the scope of the analysis and might save time during model
development and verification.
1
At the MATLAB command line, type sldemo_mdladv.
2
From the model window, select Analysis > Model Advisor > Model Advisor to
open the Model Advisor.
3
A System Selector — Model Advisor dialog box opens. Click OK.
4
If the By Product folder is not displayed in the Model Advisor window, select Show
By Product Folder from the Settings > Preferences dialog box.
5
In the left pane of the Model Advisor window, expand By Product > Simulink.
Select the Show report after run check box to see an HTML report of check results
after you run the checks.
6
Run the selected checks by clicking the Run selected checks button. After the
Model Advisor runs the checks, an HTML report displays the check results in a
browser window. The check Identify unconnected lines, input ports, and
output ports triggers a warning.
7
In the left pane of the Model Advisor window, select the check By Product >
Simulink > Identify unconnected lines, input ports, and output ports.
8
In the Model Advisor window, click the Enable highlighting button ( ).
• The model window opens. The blocks causing the Identify unconnected lines,
input ports, and output ports check warning are highlighted in yellow.
• The Model Advisor Highlighting window opens with a link to the Model Advisor
window. In the Model Advisor window, you can find more information about the
check results and how to fix the warning condition.