User`s guide

Link Multiple Model Objects to a Requirements Document
2-21
Link Multiple Model Objects to a Requirements Document
You can link multiple Simulink and Stateflow objects to a requirement. The workflow is:
1
In the requirements document, select the requirement.
2
In the Simulink Editor or Stateflow Editor, select the objects to link to the selected
requirement. You can select multiple objects by holding down the Shift key while
you click each object that you want to select. Note that you can only select multiple
objects in the same diagram.
3
Right-click one of the selected objects to open the context menu and hover over
Requirements Traceability.
4
Select one of the selection-based linking options:
• Link to Selection in MATLAB
• Link to Selection in Word