Manualshelf

User`s guide

ManualsBrandsMATLAB ManualsOtherSIMULINK VERIFICATION AND VALIDATION - S
471472473474475476477478479480
Top-Level Model Coverage Report
19-37
If you set Force block reduction off, the report contains no coverage data for this block
because the minimum input to the MinMax1 block is always 1.
If you do not set Force block reduction off, the report contains no coverage data for
reduced blocks.
Relational Boundary
On the Coverage tab, if you select the Relational Boundary coverage metric, the
software creates a Relational Boundary table in the model coverage report for each model
object that is supported for this coverage. The table applies to the explicit or implicit
relational operation involved in the model object. For more information, see: