User`s guide

2 Links Between Models and Requirements
2-12
Configure RMI for IBM Rational DOORS or Microsoft ActiveX
Navigation
To use the features of the Requirements Management Interface (RMI), you must
communicate with external software products such as Microsoft Office and IBM Rational
DOORS.
Initial configuration steps are required to setup the RMI if you need to:
• Use the RMI with DOORS applications (PC only).
•
Use ActiveX
®
controls for navigation from Microsoft Office documents to Simulink
models. You might need to register ActiveX controls when you work with existing
requirements documents (PC only).
You can setup the initial configuration for both cases by running this command:
rmi setup
If you do not have DOORS installed on your system, the rmi setup command does not
install the DOORS API.
If the rmi setup command fails to detect a DOORS installation on your system, and you
know that the DOORS software is installed, enter the following command:
rmi setup doors
This command prompts you to enter the path to your DOORS installation, and then
installs the required files.