User`s guide

7 Navigation from Requirements Documents
7-12
2
Select the Throttle Sensor header.
3
In the slvnvdemo_fuelsys_officereq model, open the engine gas dynamics
subsystem.
4
Right-click the Throttle & Manifold subsystem and select Requirements
Traceability > Link to Selection in Word.
5
The RMI inserts an URL-based link into the requirements document.
Insert Navigation Object That Links to Multiple Simulink Objects
If you have several Simulink objects that correspond to one requirement, you can link
them all to that requirement with a single navigation object. This eliminates the need to
insert multiple navigation objects for a single requirement. The Simulink objects must be
available in the same model diagram or Stateflow chart.
The workflow for linking multiple Simulink objects to one Microsoft Word requirement is
as follows:
1
Make sure that the RMI is configured to insert navigation objects into requirements
documents, as described in “Enable Linking from Microsoft Office Documents to
Simulink Objects” on page 7-10.
2
Select the Microsoft Word requirement to link to.
3
Select the Simulink objects that need to link to that requirement.
4
Right-click one of the Simulink objects and select Requirements Traceability >
Link to Selection in Word.
A single navigation object is inserted at the selected requirement.
5
Follow the navigation object link in Microsoft Word to highlight the Simulink objects
that are linked to that requirement.
Customize Microsoft Office Navigation Objects
If the RMI is configured to modify destination for bi-directional linking, the RMI inserts a
navigation object into your requirements document. This object looks like the icon for the
Simulink software: