User`s guide

Microsoft Office
7-11
To enable linking from a Microsoft Office document to the example model:
1
Open the model:
slvnvdemo_fuelsys_officereq
Note: You can modify requirements settings in the Requirements Settings dialog
box. These settings are global and not specific to open models. Changes you make
apply not only to open models, but also persist for models you subsequently open. For
more information about these settings, see “Requirements Settings” on page 2-16.
2
Select Analysis > Requirements Traceability > Settings.
The Requirements Settings dialog box opens.
3
On the Selection Linking tab of the Requirements Settings dialog box:
• Enable Modify destination for bi-directional linking.
When you select this option, every time you create a selection-based link from
a Simulink object to a requirement, the RMI inserts a navigation object at the
designated location in the requirements document.
• To specify one or more user tags to apply to the links that you create, in the
Apply this user tag to new links field, enter the tag names.
For more information about user tags, see “User Tags and Requirements
Filtering” on page 4-25.
4
Click Close to close the Requirements Settings dialog box. Keep the
slvnvdemo_fuelsys_officereq model open.
Insert Navigation Objects in Microsoft Office Requirements Documents
Use selection-based linking to create a link from the slvnvdemo_fuelsys_officereq
model to a requirements document. If you have configured the RMI as described in
“Enable Linking from Microsoft Office Documents to Simulink Objects” on page 7-10,
the RMI can insert a navigation object into the requirements document.
1
Open the Microsoft Word requirements document:
matlabroot/toolbox/slvnv/rmidemos/fuelsys_req_docs/
slvnvdemo_FuelSys_RequirementsSpecification.docx