User`s guide

5 Requirements Links Maintenance
5-4
Validate Requirements Links in a Model
In this section...
“Check Requirements Links with the Model Advisor” on page 5-4
“Fix Invalid Requirements Links Detected by the Model Advisor” on page 5-7
Check Requirements Links with the Model Advisor
To make sure that every requirements link in your Simulink model has a valid target in
a requirements document, run the Model Advisor Requirements consistency checks:
1
Open the example model:
slvnvdemo_fuelsys_officereq
2
Open the Model Advisor to run a consistency check by selecting Analysis >
Requirements Traceability > Check Consistency.
In the Requirements Consistency Checking category, all the checks are selected.
For this tutorial, keep all the checks selected.
These checks identify the following problems with your model requirements.
Consistency Check Problem Identified
Identify requirement links with missing
documents
The Model Advisor cannot find the requirements
document. This might indicate a problem with
the path to the requirements document.
Identify requirement links that specify
invalid locations within documents
The Model Advisor cannot find the designated
location for the requirement. This check is
implemented for:
• Microsoft Word documents