User`s guide

Customize Requirements Traceability Report for Model
4-7
Customize Requirements Traceability Report for Model
In this section...
“Create Default Requirements Report” on page 4-7
“Report for Requirements in Model Blocks” on page 4-15
“Customize Requirements Report” on page 4-17
“Generate Requirements Reports Using Simulink” on page 4-22
Create Default Requirements Report
If you have a model that contains links to external requirements documents, you can
create an HTML report that contains summarized and detailed information about those
links. In addition, the report contains links that allow you to navigate to both the model
and to the requirements documents.
You can generate a default report with information about all the requirements associated
with a model and its objects.
Note: If the model for which you are creating a report contains Model blocks, see “Report
for Requirements in Model Blocks” on page 4-15.
Before you generate the report, add a requirement to a Stateflow chart to see information
that the requirements report contains about Stateflow charts:
1
Open the example model:
slvnvdemo_fuelsys_officereq
2
Open the fuel rate controller subsystem.
3
Open the Microsoft Word requirements document:
matlabroot/toolbox/slvnv/rmidemos/fuelsys_req_docs/...
slvnvdemo_FuelSys_RequirementsSpecification.docx
4
Create a link from the control logic Stateflow chart to a location in this document.
5
Keep the example model open, but close the requirements document.
To generate a default requirements report for the slvnvdemo_fuelsys_officereq
model: