User`s guide

Set Simulink 3D Animation Preferences
2-17
Figure Preferences
The Simulink 3D Animation figure has a number of preferences:
• “Figure Rendering Preferences” on page 2-18
• “Figure 2-D Recording Preferences” on page 2-20
• “Figure Frame Capture Preferences” on page 2-22
Figure Appearance Preferences
The figure appearance preferences apply to the 3D World Editor and Simulink 3D
Animation Viewer. Some of these preferences also apply to Simulink 3D Animation Web
Viewer, as noted below.
To access the virtual figure appearance preferences:
1
From the MATLAB Toolstrip, in the Home tab, in the Environment section, select
Preferences.
2
In the left pane of the Preferences dialog box, select Simulink 3D Animation.
3
In the left pane under Simulink 3D Animation, select Figure.
The Simulink 3D Animation Figure Preferences dialog box opens in the right pane,
with the Appearance tab open.
4
Set the preferences as desired. See the following table for the rendering preferences
you can change. Click OK to save the settings.
Property Value Description
Toolbar 'on' | 'off'
Default: 'on'
Specifies whether the toolbar is
displayed.
Tooltips 'off' | 'on'
Default: 'on'
Specifies whether tooltips are
displayed.
Status bar 'off' | 'on'
Default: 'on'
Specifies whether status bar is
displayed.
Also applies to the Simulink 3D
Animation Web Viewer.