User`s guide

8 Simulink 3D Animation Stand-Alone Viewer
8-12
Movement Mode Zone and Description
Examine Outer -- Click and drag the mouse up and down to move forward
and backward. Drag the mouse left and right to slide left or right.
Inner -- Click and drag the mouse to rotate the viewpoint around
the origin of the scene.
Fly Outer -- Click and drag the mouse to tilt the view either left or
right.
Inner -- Click and drag the mouse to pan the camera up, down,
left, or right within the scene.
Center -- Click and drag the mouse up and down to move forward
and backward. Move the mouse left or right to turn in either of
these directions.
If your virtual world contains sensors, these sensors take precedence over mouse
navigation at the sensor's location. In this case, mouse navigation is still possible through
the right or middle mouse buttons.
Keyboard — You can also use the keyboard to navigate through a virtual world. It can
be faster and easier to issue a keyboard command, especially if you want to move the
camera repeatedly in a single direction. The following table summarizes the keyboard
commands and their associated navigation functions. Note that the letters presented do
not need to be capitalized to perform their intended function.
Orbisnap Keyboard Navigation
Keyboard Command Navigation Function
Backspace Undo move.
F9 Straighten up and make the camera stand on the horizontal
plane of its local coordinates.
+/- Zoom in/out.
F6 Toggle the headlight on/off.
F7 Toggle the navigation zones on/off.
F5 Toggle the wireframe option on/off.
F8 Toggle the antialiasing option on/off.