User`s guide

7 Viewing Virtual Worlds
7-8
Open the Simulink 3D Animation Viewer
In this section...
“Open from the VR Sink Block” on page 7-8
“Open from the Command Line” on page 7-8
Open from the VR Sink Block
You can open the Simulink 3D Animation Viewer by double-clicking a VR Sink block in
the Simulink Editor.
You can configure a VR Sink block to automatically open the Simulink 3D Animation
Viewer.
1
In the Simulink Editor, double-click the VR Sink block to open the Simulink 3D
Animation Viewer.
2
From the Simulink 3D Animation Viewer Simulation menu, select Block
parameters.
3
Select Open VRML Viewer automatically.
4
Click OK.
Open from the Command Line
Use vrview. For example, to open the vrbounce virtual world in the Simulink 3D
Animation Viewer, use vrview('vrbounce').