User`s guide

Signal From Workspace
5-391
Form output after final data value by
Specifies the output after all of the specified signal samples have been
generated. The block can output zeros for the duration of the simulation
(
Setting to zero), repeat the final data sample (Holding Final Value) or
repeat the entire signal from the beginning (
Cyclic Repetition). Tunable.
Supported
Data Types
See Also
See the sections below for related information:
•“Discrete-Time Signals” on page 3-3
•“Multichannel Signals” on page 3-11
•“Benefits of Frame-Based Processing” on page 3-14
•“Creating Signals Using the Signal From Workspace Block” on page 3-38
“Importing Signals” on page 3-62
(MATLAB commands for casting values to certain data types are provided in
parentheses.)
Boolean (
boolean)
8-, 16-, and 32-bit signed integer (
int8, int16, int32)
8-, 16-, and 32-bit unsigned integer (
uint8, uint16, uint32)
Single-precision floating point (
single)
Double-precision floating point (
double)
From Wave Device DSP Blockset
From Wave File DSP Blockset
Signal From Workspace DSP Blockset
To Workspace Simulink
Triggered Signal From Workspace DSP Blockset