Installation guide

Perfor ming Source Control Actions from the Editor/Debugger, Simulink, or Stateflow o n Windows
Performing Source Control Actions from the
Editor/Debugger, Simulink, or Stateflow on Windows
Yo u can create or open a file in the Editor/Debugger, Simulink, or Stateflow
and perform most source control actions from their File > Source Control
menus, rather than from the Current Directory browser as described in
previous sections. Following are some differences in the source control
interface p roces s when you use the Editor/Debugger, Simulink, or Stateflow:
• You can perform actions on only one file at time.
• Some of the dialog boxes have a different icon in the title bar. For exam ple,
the Check out file(s) dialog box uses an M-file Editor/Debugger document
icon instead of the MATLAB icon.
• You canno t add a new (
Untitled) file, but must instead first save the file.
• You cannot register projects from Simulink o r Stateflow. Instead, register
a project using the Current Directory browser, as described in “Register
Source Control Project with MATLAB” on page 9-7.
9-23