User`s guide

2 Introduction
2-6
Note: The toolbox supports only connections to IEEE 1394 (FireWire) DCAM-compliant
devices using the Carnegie Mellon University DCAM driver. The toolbox is not
compatible with any other vendor-supplied driver, even if the driver is DCAM compliant.
You can add support for additional hardware by writing an adaptor. For more
information, see “Support for Additional Hardware” on page 15-2.
Note: With previous versions of the Image Acquisition Toolbox, the files for all of the
adaptors were included in your installation. Starting with version R2014a, each adaptor
is available separately through the Support Package Installer. In order to use the Image
Acquisition Toolbox, you must install the adaptor that your camera uses. See “Image
Acquisition Support Packages for Hardware Adaptors” on page 4-2 for information
about installing the adaptors.