User`s guide

10 Configuring GigE Vision Devices
10-2
Types of Setups
The Image Acquisition Toolbox software supports GigE Vision devices. The following
sections describe information on installing and configuring the devices to work with the
Image Acquisition Toolbox software. Separate troubleshooting information is found in
“Troubleshooting GigE Vision Devices on Windows” on page 16-26.
Note: Not all cameras that use Ethernet are GigE Vision. A camera must have the GigE
Vision logo appearing on it or its data sheet to be a GigE Vision device.
There are five different setups you can use for GigE Vision cameras.
• Direct to a PC not on a network — PC is connected to camera with a Cat 5e or 6
Ethernet cable. PC is not on a network. This is one of the setups that offers the best
acquisition speed.
• Direct to a PC on a network, using two Ethernet cards — PC is connected to camera
with a Cat 5e or 6 Ethernet cable. PC is connected to a network. This is one of the
setups that offers the best acquisition speed.
• Indirect to a PC on a network, with PC and camera on same subnet — PC is
connected to a network with a Cat 5e or 6 Ethernet cable. Camera is connected to the
same network with a Cat 5e or 6 Ethernet cable. You may connect multiple cameras
to the network using separate cables.
• Multiple cameras to a PC directly, using multiple Ethernet cards — PC is connected
to camera 1 with a Cat 5e or 6 Ethernet cable. PC is connected to camera 2 with a
separate Cat 5e or 6 Ethernet cable. PC is optionally connected to a network. This is
one of the setups that offers the best acquisition speed.
• Multiple cameras to a PC directly, using switch or hub — PC is connected to a switch
or hub directly with a Cat 5e or 6 Ethernet cable. Camera 1 is connected to switch/
hub with a Cat 5e or 6 Ethernet cable. Camera 2 is connected to the switch/hub
with a separate Cat 5e or 6 Ethernet cable. PC is optionally connected to a network.
Alternatively, switch/hub is optionally connected to a network.