User`s guide

Data Logging
Data Logging
In this section.. .
“Overview” on page 5-3
“Trigger Properties” on page 5 -4
Overview
When a trigg er occurs, the toolbox sets the obje ct’s Logging property to 'on'
and starts storing the acquired frames in a buffer in memory, a disk file,
or both. When the acquisition stops, the toolbox sets the object’s
Logging
property to 'off'.
The following figure illustrates when an object moves into a logging state a nd
the relation betwe en running a nd logging states.
Logging State Transitions
Note After Lo gging is set to 'off',itispossiblethattheobjectmightstill
be logging data to disk. To determine when disk logging is complete, check
the value of the
DiskLoggerFrameCount property. For more information, see
“Logging Image Data to D isk” on page 5-40.
5-3