User`s guide

Tar get Preferences
block changes, the kinds of information you store in listed sections
may change. Generally, the Contents list contains these strings:
•
Code — Allow code to be stored in the section in Name.
•
Data — Allow data to be stored in the section in Name.
•
Code and Data — Allow code and data to be stored i n the
section in Name. When you add a new section, this setting is
the default for the contents.
You may add or use as many sections of each type as you need,
within the limits of the memory on your processor.
Add
Click Add to add a new section to the list. When you click Add ,
thenewsectionappearsonthelist.
Remove
This option lets you remove a section from the section list. Select
the section to rem ove from the list, and click Rem ove to delete
the section.
Sections and related options are defined as symbols to the project
generator component. Section options for new processors are not
labeled until you a dd the labels.
Processor Custom Code
Thelistontheleftsideofthepaneshowsthekindsofcustomcodeyou
can specify for y our processor. Each time you use your custom p rocessor
as defined in this dialog box, the custom code you enter here applies.
You can enter custom code in the categories in the following table.
Custom Code Entr y
Description
Source files
Enter the full paths to source code files to use
with this processor. By default there are no
entries in this parameter. Enter each source
file on a new line.
9-116