User`s guide

Targ et Preferences

burst. Enter a value from –4096 (decrement) to 4095

(increment).

To disable incrementing or decrementing the address

pointer, set Burst step to 0. For example, because

McBSP does no t u se FIFO, you must conﬁgure D MA to

maintain the correct sequence of the McBSP data by

moving each word of the data individually. Accordingly,

when you use DMA to transmit or receive McBSP data,

set Burst size to 1 word and Burst step to 0.

This parameter corresponds to bits 15-0

(SRCBURSTSTEP) in the Source Burst Step

Size Register (SRC_BURST_STEP).

Note This parameter is based on a 16-bit word size. If

you set Data size to

32 bit,doublethevalueofthis

parameter.

Note When you select Use DMA (with C28x3x) the

C280x/C28x3x ADC block, this parameter is 1.

• Transfer step

Set the number of 16-bit words by which to increment or

decrement the current address pointer before the nex t

transfer. Enter a value from –4096 (decrement) to 4095

(increment).

To disable incrementing or decrementing the address

pointer, set Transfer step to 0.

This parameter corresponds to bits 15-0

(SRCTRANSFERSTEP) Source Transfer Step

Size Register (SRC_TRANSFER_STEP).

9-99