User`s guide

Tar get Preferences
This parameter corresponds to bit 1 (NACK) of the Interrupt
Enable Register (I2CIER).
Enable AL interrupt
Enable arbitra t ion-lost interrupt.
When enabled, the I2C module generates an interrupt (AL
bit = 1) when the I2C module is operating as a master
transmitter and looses an arbitration contest with another
master transmitter.
This parameter corresponds to bit 0 (AL) of the Interrupt
Enable Register (I2CIER).
SCI_A
The serial communications interface parameters you can set for
module A. These parameters are:
Baud rate
Baud rate for transmitting and receiving data. Select from
115200 (the default), 57600, 38400, 19200, 9600, 4800, 2400,
1200, 300,and110.
Blocking Mode
If this option is set to True, system waits until data is
available to read (when data length is reached). If this
option is set to False, system checks FIF O periodically (in
polling mode) to s ee if there is any data to read. If data is
present, it reads and outputs the contents. If no data is
present, it outputs the last va lue and continue s.
Character length bits
Length in bits of each transmitted or received character,
set to 8 bits.
Communication mode
Select
Raw_data or Protocol mode. Raw data is
unformatted and sent whenever the transmitting side is
ready to send, whether the receiving side is ready or not.
9-78