User`s guide

Tar get Preferences
memory map for your processor. Both steps are essential for generating
code for any board that is custom or explicitly supported, such as the
C6711 DSK or the DM642 EVM .
Unlike most other blocks, you cannot open the bl ock dialog box until
you add the block to a model. When yo u open the block dialog, the block
attempts to connect to your processor. It cannot make the connection
when the block is in the library and returns an error message.
Note If you do not have Texas Instruments’ Code C ompose r Studio
software installed, you cannot open this block.
Generating Code from Model Subsystems
Real-Time Workshop software provides the ability to generate code
from a selected subsystem in a model. To generate code for custom
C2xxx, C5xxx, or C6xxx processor-based hardware from a subsystem,
the subsystem model must include a Target Preferences block.
Dialog
Box
This reference page section contains the following subsections:
• “Board Info Pane” on page 9-48
• “Memory Pane” on page 9-52
• “Physical M emory Options” on page 9-54
• “Sections P an e” on pa ge 9-58
• “DSP/BIOS Pane” on page 9-62
• “Perip herals P ane” on page 9-65
• “New Processor D ialog Box” on page 9 -107
9-46