User guide

84 www.xilinx.com System Generator for DSP User Guide
UG640 (v 12.2) July 23, 2010
Chapter 1: Hardware Design Using System Generator
• Drag a template block into the library. (Templates can be found in the Simulink library
browser under Simulink/Ports & Subsystems/Configurable Subsystem.)
• Rename the template block if desired.
• Save the library.
• Double click to open the template for the library.
• In the template GUI, turn on each checkbox corresponding to a block that should be
an implementation.
• Press OK, and then save the library again.