User guide

System Generator for DSP User Guide www.xilinx.com 287
UG640 (v 12.2) July 23, 2010
Installing Your Board for Ethernet Hardware Co-Simulation
Setup the ML506 board
The figure below illustrates the ML506 components of interest in this setup procedure:
1. Position the ML506 board so the Xilinx logo is oriented near the lower-left corner.
2. Make sure the power switch, located in the upper-right corner of the board, is in the
OFF position.
Ethernet
Power Connector
Power Switch
LCD
Ethernet Status LEDs
Configuration Address
DIP Switches (SW3)
Ethernet Mode Select
jumpers (J22 & J23)