User guide

System Generator for DSP User Guide www.xilinx.com 261
UG640 (v 12.2) July 23, 2010
Frame-Based Acceleration using Hardware Co-Simulation
memory information by clicking on the (+) or (-) icons located adjacent to the shared
memory icons.
10. Close the parameters dialog box.
You are now ready to insert the hardware co-simulation block in the original design. Before
continuing on with the next steps, it is worthwhile to either rename the design or create a
backup of the original since you will be making modifications.
11. Remove the hw_cosim subsystem from the design.
12. Insert the hardware co-simulation block in place of the hw_cosim subsystem.
13. Configure the hardware co-simulation block with any settings necessary to co-
simulate using single-step clock mode.
14. Press the Simulink Start button to start the design.