User guide

236 www.xilinx.com System Generator for DSP User Guide
UG640 (v 12.2) July 23, 2010
Chapter 3: Using Hardware Co-Simulation
2. Use the Configuration tab to select the Configuration Method:
♦ For the Download cable panel, choose Point-to-point Ethernet.
♦ For JTAG-based download cables (Parallel Cable IV or Platform USB), change
the cable speed if the default value is not suitable for the cable in use.
♦ Change the Configuration timeout (ms) value only when necessary. The default
value should suffice in most cases. A larger value is needed when it takes a
considerable amount of time to re-establish a network connection with the FPGA
board after device configuration completes.
♦ If there is a Video I/O daughter card attached to the ML402 board, select Video
I/O Daughter Card (VIODC) from the Configuration profile pulldown menu