User guide

System Generator for DSP User Guide www.xilinx.com 215
UG640 (v 12.2) July 23, 2010
Designing with Embedded Processors and Microcontrollers
Note: Notice that the new C-code is automatically detected and compiled. If there is no syntax error
and everything goes well, you should see a screen-shot similar to the one shown below
.
10. Before you start debugging your design, you may need to make sure that the COM
port setting in SDK STDIO is the same with what is being set on your PC.
Verify the COM port setting on your PC as follows:
a. Right-click on My Computer > Manage, then click on Device Manager.
b. Expand the Ports (COM & LPT) entry